concrete with partial replacement of crushed granite fine by sand

concrete with partial replacement of crushed granite fine by sand

EXPERIMENTAL INVESTIGATION ON CONCRETE WITH

2017-3-29  6. Manasseh JOEL –“Use of Crushed Granite Fine as Replacement to River Sand in Concrete Production” Leonardo Electronic Journal of Practices and Technologies ISSN 1583-1078 Issue 17, July -December 2010p. 85 96 7 .O. S. Olaniyan, O.M. Afolabi and O.M. Okeyinka “Granite Fines as a Partial Replacement for Sand

Characteristic Studies on Concrete by Partial

2019-9-10  In present study the detailed characteristic studies of concrete is carried out by partial replacement of natural sand by waste granite powder in concrete composition with different percentages (0%, 10%, 20%, 30%, 40%, 50%).The mechanical properties of concrete like compressive strength, tensile strength are carried out by replacing the

Experimental Study on Partial Replacement of Fine

2016-5-14  Experimental Study on Partial Replacement of Fine Aggregate by Granite Powder in Concrete Hence in the present investigation more emphasis is given to study the concrete using sand replacement by Granite powder values of 33.07N/mm2 and 2.04N/mm2 respectively were obtained when crushed granite fine was replaced with 20% river sand

Use of Crushed Granite Fine as Replacement to River

Based on the above economic analys is 20% crushed granite fine. is recommended for use in the production of grade C40 concrete for road work. The use of only Makurdi river sand as fine

Use of Crushed Granite Fine as Replacement to River

Use of Crushed Granite Fine as Replacement to River Sand in Concrete Production Manasseh JOEL 86 Introduction Concrete is an artificial conglomerate stone made essentially of Portland cement,

Partial replacement of sand by granite powder in

Strength And Durability Properties Of Concrete Containing Quarry Rock Dust As Fine Aggregate Narmatha.M. " Partial replacement of sand by granite powder in concrete" International Journal of

An Experimental Study on Partial Replacement of Sand

2016-3-3  the behaviour of M20 grade concrete with the use of granite fines as a partial replacement for sand in 5%, 15%, 25%, 35% and 50%; and based onthe results obtained for compressive, split-tensile and flexural tests, it was recommended that 35% of sand can

USE OF CRUSHED GRANITE FINE AS REPLACEMENT

The suitability of Crushed granite fine (CGF) to replace river sand in concrete production for use in rigid pavement was investigated. Slump, compressive and indirect tensile strength tests were performed on fresh and hardened concrete.28 days Peak compressive and indirect tensile strength values of 40.70N/mm 2 and 2.30N/mm 2 respectively was obtained, with the partial replacement of river

Experimental study of concrete made with granite and

2016-9-1  Kala conducted tests on granite powder as a partial sand replacement in high performance concrete and showed the beneficial effects on its mechanical properties. Of all the six mixtures he considered, concrete with 25% of granite powder (GP25) was found to be superior to other percentages of granite powder concrete as well as conventional.

Partial replacement of sand with marble waste and

2020-11-2  The partial replacement of sand with marble waste and scoria can save the cost of concrete up to 4.5% when compared to the control mix. According to the cost analysis as the percentage replacement rate of marble waste increase, the cost also increases the reason behind is the abundance of marble is low around Bahir Dar, Ethiopia and there is

EXPERIMENTAL INVESTIGATION ON CONCRETE WITH

2017-3-29  6. Manasseh JOEL –“Use of Crushed Granite Fine as Replacement to River Sand in Concrete Production” Leonardo Electronic Journal of Practices and Technologies ISSN 1583-1078 Issue 17, July -December 2010p. 85 96 7 .O. S. Olaniyan, O.M. Afolabi and O.M. Okeyinka “Granite Fines as a Partial Replacement for Sand

USE OF CRUSHED GRANITE FINE AS REPLACEMENT

The suitability of Crushed granite fine (CGF) to replace river sand in concrete production for use in rigid pavement was investigated. Slump, compressive and indirect tensile strength tests were performed on fresh and hardened concrete.28 days Peak compressive and indirect tensile strength values of 40.70N/mm 2 and 2.30N/mm 2 respectively was obtained, with the partial replacement of river

REPLACEMENT OF NATURAL SAND IN CONCRETE BY

REPLACEMENT OF NATURAL SAND IN CONCRETE BY successful utilization of Crushed Granite Fine based on findings from the study the partial replacement of Makurdi river sand with 20%

Toc H Institute of Science & Technology, Arakunnam,

2019-7-12  concrete mixtures in which fine aggregate (sand) was partially replaced with fly ash, copper slag and granite powder using M 30 grade concrete. Fine aggregate (sand) was replaced with four different percentages (0%, 25%, 50% and 75%) of fly ash, copper slag and granite powder by weight. Tests were performed for properties of fresh concrete.

Partial Replacement of Coarse Aggregate with Broken

2018-8-12  Abstract— The study reports on experimental investigation on the suitability of the use of broken tiles as partial replacement for crushed granite in concrete production. Control mixing ratio of 1:2:4 batched by weight with water cement ratio of 0.55 was used. The percentage replacement varied from 0% to 40% at intervals of 5%.

Flexural Behavior of Concrete by Partial Replacement of

2017-4-26  glass as a pozzolana as partial replacement of cement and waste granite powder as partial replacement of fine aggregate in the concrete. To achieve 28 days characteristic compressive strength To study the compressive strength of glass powder + granite powder concrete and conventional concrete.

Effect of Partial Replacement of Crushed Fine

Consumption of concrete, mortar and other cement based composites is over 20 billion tonnes per annum, globally. Natural sand/crushed fine aggregates(CFA) are important ingredients of concrete. Aggregates contributes 60% to 80% of the total concrete volume. The available sources of natural sand are getting exhausted because of excessive sand mining.

Experimental study of concrete made with granite and

2016-9-1  Kala conducted tests on granite powder as a partial sand replacement in high performance concrete and showed the beneficial effects on its mechanical properties. Of all the six mixtures he considered, concrete with 25% of granite powder (GP25) was found to be superior to other percentages of granite powder concrete as well as conventional.

Partial replacement of sand with marble waste and

2020-11-2  The partial replacement of sand with marble waste and scoria can save the cost of concrete up to 4.5% when compared to the control mix. According to the cost analysis as the percentage replacement rate of marble waste increase, the cost also increases the reason behind is the abundance of marble is low around Bahir Dar, Ethiopia and there is

Producing of workable structural lightweight concrete

2020-5-5  In the third series (S3), the red fine crushed clay brick (RFCCB) aggregate was utilized to replace natural sand with same replacement ratios (i.e. 10%, 20%, and 30%). In the fourth series (S4), the coarse crushed clay brick (CCCB) aggregate concrete was produced by replacement of natural coarse aggregate (100% by volume) with yellow (YCCCB

Use of Crushed Granite Fine as Replacement to River

Use of Crushed Granite Fine as Replacement to River Sand in Concrete Production . By Manasseh JOEL. Abstract. The suitability of Crushed granite fine (CGF) to replace river sand in concrete production for use in rigid pavement was investigated. Slump, compressive and indirect tensile strength tests were performed on fresh and hardened concrete

Flexural Behavior of Concrete by Partial Replacement of

2017-4-26  glass as a pozzolana as partial replacement of cement and waste granite powder as partial replacement of fine aggregate in the concrete. To achieve 28 days characteristic compressive strength To study the compressive strength of glass powder + granite powder concrete and conventional concrete.

Partial Replacement of Coarse Aggregate with Broken

2018-8-12  Abstract— The study reports on experimental investigation on the suitability of the use of broken tiles as partial replacement for crushed granite in concrete production. Control mixing ratio of 1:2:4 batched by weight with water cement ratio of 0.55 was used. The percentage replacement varied from 0% to 40% at intervals of 5%.

Strength and Durability Properties of Granite Powder

2017-12-1  Accordingly, this paper will examine the properties of concrete by varying the granite powder as a replacement of sand in the concrete that have originated from granite crushed unites along with admixtures such as silica fume, fly ash, ground granulated blast-furnace slag and superplasticiser as a partial replacement of cement. 1.1.

[PDF] Strength Characteristics of Concrete with Partial

This paper presents the results of concrete mix with partial replacement of fine aggregate by quarry dust and simultaneous partial replacement of coarse aggregate by laterite stone aggregate respectively on compressive strength, split tensile strength, flexural strength and workability of concrete. Concrete mixes containing 0%, 10%, 20%, 25 % and 30%, replacement (by weight) of fine aggregate

Effect of Partial Replacement of Crushed Fine

Consumption of concrete, mortar and other cement based composites is over 20 billion tonnes per annum, globally. Natural sand/crushed fine aggregates(CFA) are important ingredients of concrete. Aggregates contributes 60% to 80% of the total concrete volume. The available sources of natural sand are getting exhausted because of excessive sand mining.

A Review of Partial Replacement of Fine Aggregate &

2017-10-11  the crushed granite with coconut shell aggregate can be economically used in reinforced concrete. 3. CONCLUSIONS [2]From the above mentioned work of assorted researchers, it's clear that waste glass powder & coconut shell is used as a partial replacement of fine aggregate &

PARTIAL REPLACEMENT OF NATURAL RIVER SAND WITH

2015-10-30  The use of crushed rock sand as a partial replacement of river sand in concrete production was and 0.59 for 0 % to 100 % natural sand replacement. The slump ranged between 49 and 60 mm for 0 % to 100 % natural sand replacement. N/mm2. The effective natural sand (RS) replacement ranged between 0 and 60 % with the best results achieved at 20 %

Suitability of Crushed Manufactured Sand for

2020-11-28  C-25 concrete properties with partial replacement of river sand by manufactured sand. Independent variables • Percentage of manufactured sand. • Properties of fine and coarse aggregates. • Curing age of cubes. Research design The study was an experimental study of C-25 concrete properties with and without replacement of manufactured sand.

Producing of workable structural lightweight concrete

2020-5-5  In the third series (S3), the red fine crushed clay brick (RFCCB) aggregate was utilized to replace natural sand with same replacement ratios (i.e. 10%, 20%, and 30%). In the fourth series (S4), the coarse crushed clay brick (CCCB) aggregate concrete was produced by replacement of natural coarse aggregate (100% by volume) with yellow (YCCCB